Bully Dog 81040 Rapid Flow - Manual (Page 9)

8
8
rAPid FlOW inSTAllATiOn
rapid Flow exhaust # 81040
9. At this point it is time to install the Straight Pipe(s). You will need to
measure the Straight Pipe to the correct length, keeping in mind that
you will need to have an extra 3 inches of overlap when you cut the
pipe. Do not cut the flair out.
10. Once the entire exhaust system is installed,
inspect the system to ensure that no part of the
exhaust is in direct contact with the chassis or
body; adjustments may be necessary. Having
any part of the exhaust system in direct contact
with any part of the body or chassis will the
cause the exhaust to rattle.
11. Return to each of the Clamps
and tighten with a 9/16”
wrench. Again, do not over
tighten Clamps.
Straight Pipe
Muffler
Hanger B
3”
9/16”
IMpoRTaNT: Do not over-tighten clamps. Too much torque will result in deformation of the exhaust. For best results
when doing the installation, tighten the clamps enough to hold the exhaust pieces in place, but don’t tighten down until
the entire exhaust system is installed.
Install Tail Pipe Tip
Complete System Installed with Stainless Steel Tip