Bully Dog 81040 Rapid Flow - Manual (Page 5)

4
4
rAPid FlOW inSTAllATiOn
rapid Flow exhaust # 81040
REMOVAL OF STOCk EXHAUST SySTEM
In these steps you will remove the stock exhaust
system.
1. Use a sawzall to cut the exhaust immediately behind the
muffler.
2. Cut the exhaust using a sawzall 4” behind the catalytic
converter.
3. Remove each piece of the stock exhaust system, including
the stock exhaust hangers. To make remove the hangers
an easier process, it is recommended that you use a silicone
spray lubricant to spray each of the rubber hangers that
held the stock exhaust.
Cut Exhaust Behind Muffler
Cut Exhaust Directly in front of Band Clamp
Hang the Hangers