Bully Dog 81420 Rapid Flow - Manual (Page 10)

9
rAPid FlOW inSTAllATiOn
rapid Flow exhaust # 81420
IMpoRTaNT: Do not over-tighten clamps. Too much torque will result in deformation of the exhaust. For best results
when doing the installation, tighten the clamps enough to hold the exhaust pieces in place, but don’t tighten down until
the entire exhaust system is installed.
13. Once the entire exhaust system is installed, in-
spect the system to ensure that no part of the ex-
haust is in direct contact with the chassis or body;
adjustments may be necessary.
14. Return to each of the Clamps and tighten with a 9/16” wrench. Again, do not over tighten Clamps. Hav-
ing any part of the exhaust system in direct contact with any part of the body or chassis will the cause the
exhaust to rattle.
9/16” Install Straight Pipe
Complete System Installed
Straight Pipe
Hanger A
Muffler