Bully Dog 81203 Rapid Flow - Manual (Page 9)

10
10
rAPid FlOW inSTAllATiOn
rapid Flow exhaust # 81610,81203
10. Install the Muffler by connecting it to
the Front Piece Tail Pipe and then tight-
ening Hanger C.
11. At this point it is time to install the
Straight Pipe if required. Keep in mind
when you make your measurements
that you will need to leave an extra
3 inches of overlap when you cut the
straight pipe.
12. Once the entire exhaust system is installed, inspect the system to ensure that no part of the exhaust is in direct contact with
the chassis or body; adjustments may be necessary.
13. Return to each of the Clamps and tighten with a 9/16” wrench. Again, do not over tighten Clamps.
Having any part of the exhaust system in direct contact with any part of the body or chassis will cause the
exhaust to rattle.
9/16”
Complete System Installed
Adaptor Pipe
3”