Bully Dog 81203 Rapid Flow - Manual (Page 7)

8
8
rAPid FlOW inSTAllATiOn
rapid Flow exhaust # 81610,81203
2. Place all of the supplied Hangers into their appropri-
ate locations as shown in the above diagram.
3. Ensure the Firewall Bolt is cut so that the down pipe
will not rub against it.
4.Install the Down Pipe. You will use the stock band
clamp to secure the Down Pipe to the turbo. Secure
the Down Pipe by tightening the stock band clamp
with a 7/16” deep socket.
5.Secure the Second Piece Down Pipe to the Down Pipe
using one of the supplied clamps. At this point, secure
the connection so that the piece will stay, but do not
tighten down until the entire exhaust is installed.
6. Reinstall the Catalytic Converter by connecting
it to the Second Piece Down Pipe. Remember to
install the included gasket, tighten and secure
with bolts.
7/16”
Hang the Hangers
Tighten Band Clamp
Cut Firewall Bolt
Second Piece Down Pipe
Catalytic Converter
Gasket
Reinstall Catalytic Converter