Bully Dog 53205 Rapid Flow Induction (RFI) Cold Air Intake - Manual (Page 8)

13 14
RFI COLD AIR INTAKE RFI COLD AIR INTAKE
6. Reconnect the MAF and MAP sensor plugs.
7. Replace the engine cover.
• Ensure that all the mounting points are fitted into the
rubber boots on the bottom of the engine cover.
• Press down gently until all of the mounts have snapped
in place.
8. Install the RFI lid.
• Set the lid in place by lining up the latches and the
mounts.
• Snap the latches over the mount on the lid.
3. Install the silicon hose (replace the CCV tube).
a. Connect one end of the silicon hose to the CCV
breather. (See step 8, page 8.)
b. Connect the other end of the hose to the Stage 2 RFI
tube.
c. Tighten the hose clamps. (Use a flat-head screwdriver.)
4. Install the air filter
a. Connect it to the end of the MAF tube that is inside the
RFI base.
b. Tighten the band clamp (use a flat-head screwdriver).
5. Tighten all of the band clamps. (All of the parts should be in
the correct position at this point.)