Bully Dog 53205 Rapid Flow Induction (RFI) Cold Air Intake - Manual (Page 6)

9 10
RFI COLD AIR INTAKE RFI COLD AIR INTAKE
3. Remove the MAP sensor from the corner of the stock
intake box. (Use a Phillips screwdriver.)
4. Attach the MAF sensor to the RFI MAF tube.
• Use the 3 ⁄
8
″ black oxide screws provided by Bully Dog
and a Phillips screwdriver.
• IMPORTANT: Do not overtighten the screws, as this
could damage the MAF sensor.
5. Attach the MAP sensor to the Stage 2 RFI tube.
• Use the black oxide washer and 3 ⁄
4
″ black oxide screw
provided by Bully Dog.
• IMPORTANT: Do not overtighten the screws, as this
could damage the MAP sensor.
10. Remove the mounting plate.
a. Use a 10 mm socket to remove the four bolts that
secure the plate to the vehicle frame.
Preparing the RFI Intake
1. Snap the RFI MAF tube into the RFI base.
2. Remove the MAF sensor from the stock intake. (Use the
included T15 Torx® bit and a bit driver.)