Bully Dog 53254 Rapid Flow Induction (RFI) Cold Air Intake - Manual (Page 2)

1 2
TROUBLESHOOTING:
Technical support is available by calling 940-783-9914.
Tech support hours: Monday-Friday 8am-5pm Mountain Standard Time.
Before Calling Technical Support complete the following
steps:
•Visit bullydog.com, click on the Support tab located at
the top of the page and the select “technical support” from
the dropdown menu.
• If you questions aren’t anwered in the FAQ’s list, click on chat
with a tech and fill out the required information.
• All of the blank boxes must be filled out, including
Company. If you wish, just type in “none” under Company.
TABLE OF CONTENTS
INTRODUCTION ..........................................................................................................PG. 1
PARTS INCLUDED ........................................................................................................PG. 2
PARTS DESCRIPTION ..............................................................................................PGS. 3-7
INSTALLATION ....................................................................................................PGS. 8-18
REMOVING THE STOCK AIR INTAKE ................................................................PGS. 8-13
PREPARING TO INSTALL THE RFI INTAKE ...................................................... PGS. 14-15
INSTALLING THE RFI ON THE VEHICLE .......................................................... PGS. 16-18
FILTER MAINTENANCE ..............................................................................................PG. 19
PREFILTERS ..............................................................................................................PG. 20
REPLACEMENT CONE FILTER .......................................................................................PG 21
Parts Included Table of Contents
Parts Included and Tools Needed:
This section displays the parts included in the package and the tools needed to properly
install the system.
INTRODUCTION
This instruction set outlines the installation and maintenance of the Stage 2 Rapid Flow Cold Air Intake
for all GM 5.3L gasoline powered pickups. Installation of this intake takes about 20 minutes, requires
little mechanical experience and can easily be performed in a driveway even by those who have never
installed an intake on a vechicle before.
For additional help or product information, visit our website at www.bullydog.com
Parts Included
RFI Base
RFI Lid
Filter Tube w/MAF sensor mount
Stage 2 Intake Tube
Hump Silicone Coupler
Straight Silicone Coupler
(2) Silicone CCV Hose
(2) 4” Band Clamps
(2) 4.5” Band Clamps
(4) #8 Hose Clamps
(2) Stainless black oxide MAF screws
Air Filter
T-15 Torx
(3) M6x1.00 Bolt
TOOLS NEEDED
Flat head screw driver
Phillips screw driver
Bit driver
10mm socket
Socket wrench
T15 Torx Bit (included)