Bully Dog 40510 Triple Dog Gas Downloader - Manual (Page 11)

10
getting Started
getting started (starting the downloader/naVigation)
To get started, with any of the Triple Dog Gas functions, follow the steps below:
1. Make sure that your key is in the ignition and in the off position before
you plug the downloader into the vehicle’s OBDII port. The downloader
will later prompt you to turn the key to the on/run position.
2. Connect the OBDII cable that comes with the downloader into the top
of the downloader and then into the OBDII port.
3. The downloader will light up to display the opening screen, and
then it will go to a vehicle selection screen.
While in the vehicle selection screen select
your vehicle make.
4. After you select your vehicle the down-
loader will then display the Main Menu.
This Diagram illustrates how to use the buttons on the front of the downloader to navigate through the
menu systems and screen prompts given on the downloader.
Scroll Left Scroll Right
No/Exit Scroll Down
Yes/Enter Scroll Up