Bully Dog 40605 John Deere 8030 and 8020 Series Module - Manual (Page 12)

11
OPerATing inSTruCTiOnS
oPerating inStructionS:
INTERNal pOwER lEvEl SwITCh: The Rapid Power module has three power settings, Stock, Low Power
Level or High Power Level. To select different power levels remove the cover of the module box, locate the red
internal power switch, and set the switch to the desired power level per illustrations below.
Be sure to securely fasten the module cover after changing the power level. Make sure the cable exits the box
properly in the hole provided.
1. After completing the installation of the module, turn the tractor on to test if the module is working. If the
tractor starts then the module is working. If the tractor does not start, check all of the connections on the install
to be sure that they are secure and then attempt to start the tractor again.
2. Adjust performance setting to desired level and enjoy.
warranty
ON
1 2
Both switches in
the “off” position
indicates Stock
performance
First switch in
the “on” position
indicates Low Power
Level.
Second switch in
the “on” Position
indicates High Power
Level.
Both switches in
the “on” Position
indicates High Power
Level.
USB Port
Internal Power Switches
ON
1 2
ON
1 2
ON
1 2
Stock Low Power Level
External Power Switch Female Plug
(External Switch part number 40610)
High Power Level
These two positions provide the same power.
*Due to John Deere’s new software updates, the ‘High’ power level should not be used for the 08’ John Deere
8030 series tractors or any 8030 tractor that has been re-flashed by a John Deere dealer. Use of the ‘High’ power
setting with these tractors will result in warning lights and codes. If warning codes appear while operating,
shut the tractor down, adjust the module to the ‘Low’ power level, and continue operation. If problems persists
contact Bully Dog Tech Support at 1-866-285-5936.