Blomberg GSN 9487 XSP - Manual (Page 9)

8 EN
Connection to the drain
Water discharge hose can directly be
connected to the drain hole or sink’s
drainage. The length of this connection
must be min. 50 cm and max. 100 cm
from the floor.
1011
— Open the taps completely after
making the connections to check
for water leaks.
A
For your safety, close the water
inlet tap completely after the
washing programme is over.
�
��
��
��
��
��
��
��
��
��
���
��
�
���������
����
����������
�������
����
����
Permitted water temperature: up to
25°C
The dishwasher may not be connected
to open warm water devices or flow-
through water heaters.
—
Do not use old or used water inlet
hose on the new product. Use the
new water inlet hose supplied with
the product.
—
Connect the water inlet hose
directly to the water tap. Pressure
coming from the tap should be
minimum 0.3 and maximum 10
bars. If the water pressure exceeds
10 bars, a pressure relief valve
should be installed in between.
C
Use a screw-on hose connector
to connect the water inlet hose to
a water tap with a ¾ inch external
thread. If required, use a filter
insert to filter deposits from the
pipes.
1009
A discharge hose longer than 4 meters
causes dirty washing.
Attach the water discharge hose
to the drainpipe without bending it.
Tightly fix the water discharge hose to
the drainpipe in order to prevent any
dislocation of the water discharge hose
during operation of the product.
C
Drainpipe must be connected to
the sewage system and it should
not be connected to any surface
water.