Blomberg GSN 9487 XSP - Manual (Page 10)

9 EN
Adjusting the feet
If the door of the product cannot be
closed properly or if the product swings
when you push it slightly, then you need
to adjust the feet of the product. Adjust
the feet of the product as illustrated in
the installation manual supplied with the
product.
AquAvoid™plus
(depends on the model)
Protect the AquAvoid™ plus system
against water leaks that may occur at
hose inlet. Water contact with the valve
box of the system must be prevented.
Otherwise, electrical assembly will get
damaged. If the AquAvoid™ plus system
is damaged, unplug the product and call
the Authorised Service Agent.
A
As the hose set contains electrical
connections and assemblies, never
shorten or lengthen the hose with
extension hoses.
1010
����
������
Electrical connection
Connect the product to a grounded
outlet protected by a fuse complying
with the values in the “Technical
specifications” table. Manufacturer
shall not be liable for any damages
that will arise when the product is used
without grounding in accordance with
the local regulations.
—
Connection must comply with
national regulations.
— Power cable plug must be within
easy reach after installation.
A
Unplug the product after the
washing programme is over.
— The voltage and allowed fuse or
breaker protection are specified
in the “Technical specifications”
section. If the current value of the
fuse or breaker in the house is less
than 16 Amps, have a qualified
electrician install a 16 Amp fuse.
—
The specified voltage must be
equal to your mains voltage.
—
Do not make connections via
extension cables or multi-plugs.
B
Damaged power cables must be
replaced by the Authorised Service
Agent.
B
If the product has a failure, it
should not be operated unless it is
repaired by the Authorised Service
Agent! There is the risk of electric
shock!
Initial use
Before starting to use the product,
make sure that all preparations
are made in accordance with the
instructions in sections “Important
safety instructions” and “Installation”.
—
To prepare the product to do the
dishes, perform first operation
in the shortest programme with