Blizzard Lighting SnoKontrol (Rev B) - Manual (Page 13)

SNOKONTROL Manual Rev B.
Page 13
3.4.2 Running A Chase
1. Press a button then press the button.
2. Adjust the chase speed by tapping the button (up to 10
minutes between taps... seriously... that would be a long chase.)
3.4.3 Checking A Chase
1. Press and hold the button until the PROGRAM LED blinks.
2. Select the desired button
3. Press the button to switch the LED display to steps.
4. Review each scene/step individually by using the /
buttons.
3.4.4 Edit A Chase (Copy A Bank Into A Chase)
1. Press and hold the button to enter programming mode.
2. Press the desired button.
3. Select the BANK to be copied using the / buttons.
4. Press button to prepare to copy.
5. Press button to copy the bank. All LEDs will blink.
3.4.5 Edit A Chase (Copy A Scene Into A Chase)
1. Press and hold the button to enter programming mode.
2. Press the desired button.
3. Select the BANK that contains the scene to be copied using the
UP>/ buttons.
4. Press the button that corresponds to the scene to be copied.
5. Press button to copy the scene. All LEDs will blink.
3.4.6 Edit A Chase (Insert A Scene Into A Chase)
1. Press and hold the button to enter programming mode.
2. Press the desired button.
3. Press the button to switch the LED display to steps.
4. Use the / buttons to navitage between steps and
locate the insert point for the new scene. The display will read the step number ( 0-
240 )
5. Press button to prepare the insert.
6. Use the / buttons to locate the scene to insert.
7. Press the button that corresponds to the scene to be inserted.
8. Press button to insert the scene. All LEDs will blink.
3.4.7 Delete A Scene In A Chase
1. Press and hold the button to enter programming mode.
2. Press the desired button.
3. Press the button to switch the LED display to steps.
4. Use the / buttons to navitage between steps and
locate the scene to be deleted. The display will read the step number ( 0-240 )
5. Press the button to delete the scene/step. All LEDs will blink.