Blizzard Lighting SnoKontrol (Rev B) - Manual (Page 10)

SNOKONTROL Manual Rev B.
Page 10
Copyright © 2010-2013 Blizzard Lighting, LLC.
ALL RIGHTS RESERVED
3.1.4 Resetting The System
WARNING: This will reset the controller to its factory defaults. ALL PROGRAMS AND SETTINGS
WILL BE ERASED!
1. Turn the unit off.
2. Press and hold &
3. Turn the unit on while you continue to hold &
4. The settings will be reset to factory defaults.
3.1.5 Fixture Copy
This allows the user to copy the attributes of one fixture to another (IE Scanner 1 to Scanner 2)
1. Press and hold the button to be copied.
2. While holding the first button, press and hold the button to receive
the copied data.
3. Release the first button, then the second.
4. The Scanner LED indicators will flash to confirm a successful copy.
3.1.6 Fade Time Assign
This allows the user to assign fade times either globally or to PAN/TILT channels only. This is
useful because typically the user will not want to fade gobos/colors/etc.
1. Turn the controller off.
2. Hold the and buttons simultaneously.
3. Turn the controller on.
4. Press the button to toggle between the two modes. Either
all channels ( A ) or PAN/TILT channels only ( P ).
5. Press and to save the setting. All LEDs
will blink to confirm the selection.
3.2 Manual Mode
Manual mode allows direct control of all scanners. You are able to move them and change attri-
butes by using the channel faders.
Note: All changes made while in Manual Mode are temporary and will not be recorded.
1. Press the button until the Auto Trigger LED is unlit.
2. Select a button.
3. Move the faders to change fixture attributes corresponding with each fader channel.
4. Pressing the button toggles between displaying the DMX
value ( 0-255 ) and percentage ( 0-100 )