Page 16 – Blizzard Lighting Kontrol 6 Skywire(Rev. A) User Manual

Page 16

Page 16

KONTROL 6 Skywire Manual Rev. A

3.7.1 Setting Up Skywire™ Wireless DMX

1. Plug the receiver into the “DMX IN” connector of the fixture and verify it is

receiving power (the STATUS LED should illuminate.)

2. Turn on the “WD” wireless DMX power power switch on the back of the con-

troller and verify it is receiving power (the STATUS LED should illuminate.)

3. Press the RECESSED SELECTOR BUTTON on the back of the controller

to select the operating channel group. (The system will store this setting for

future use)

The 7-Color Status LED will change color to indicate the current channel group:

· GROUP 1:

RED

· GROUP 2:

GREEN

· GROUP 3:

YELLOW

· GROUP 4:

BLUE

· GROUP 5:

VIOLET

· GROUP 6:

CYAN

· GROUP 7: WHITE

4. Follow the same procedure on the receiver to select the channel group.

5. The LED will blink

RED

slowly until communication is established with the

receiver. The status LED on the receiver(s) will flash

GREEN

slowly until com-

munication is established.

6. Once the clearest channel is auto-selected, the status LEDs will blink quickly

on both the transmitter and receiver. NOTE: The color of the LED DURING op-

eration does not indicate channel group, instead it indicates whether the unit

is transmitting or receiving. That’s It!

NOTE: “GROUP” number also

corresponds to the “GROUP”

setting on our LightCaster™

wireless DMX transceiver and

wiCICLE™ products.