Barco R9000901 - Manual (Page 39)

Service Mode
7-2 5975007 BARCOGRAPHICS 808s 160996
Identification
Highlight 'Identification' with the control stick and press ENTER .
The 'Identification' screen gives information concerning :
- projector address. To change the address of your projector,
contact a qualified service technician.
- software version.
- configuration.
possible installations :
* front-ceiling
* front-table
* rear-ceiling
* rear-table
- baud rate PC : transfer speed for communication with an IBM PC
(or compatible) or MAC. The baud rate of the projector must be the
same as the baud rate of the connected computer. When there is a
difference, contact a qualified service
technician to make the appropriate changes.
- Text ON/OFF
Indicates in operational mode if the bar scale and number indicator
will be displayed and if warnings and failures will be displayed.
ON : displayed
OFF : not displayed
The status can be changed by pressing the 'TEXT' key once on the
RCU.
- Serial no. : indicates the fabrication number of the projector. This
number can be useful when calling for technical assistance.
Copy a block
The copy a block function copies the settings of a selected block into
the active block.
Highlight copy a block with the control stick and press
ENTER .
ENTER will select the highlighted item.
To copy the settings of a closed block to the block you are working
on (active block), use the control stick to select a block.
All existing settings will be overwritten with the new settings.
Press ENTER to copy the selected block. A confirmation screen will
be displayed.
If you are certain you wish to copy the contents of the selected block
into the active block, press
ENTER .
EXIT cancels the copy procedure and returns without copying the
block.
Select with or
then
to return.
SERVICE MODE
Proj. address : 001
Soft. Version : 6.00
Config. : Ceiling
Front
Baudrate PC : 9600
Text : ON
Serial No. : 103589552
GRAPHICS 808s
IDENTIFICATION
COPY A BLOCK
DELTE A BLOCK
DELETE ALL BLOCKS
CHANGE PASSWORD
CHANGE LANGUAGE
RUN TIME
SET TO MIDPOSITION
CONVERGENCE MID
DYNAMIC ASTIGMATISM
MORE...
Select with or
then
to return.
SERVICE MODE
Select with or
to copy
to return.
COPY MODE
Nr. Src Fh Fv inp conf
1 1 15.6 50 video FC
2 3 31.2 60 RGB3S RT
3 - 15.6 50 intern FC
4 2 31.5 50 RGB3S FC
5 - 33.7 60 intern FC
6
7
8
Active block nr. 1
COPY BLOCK
All settings
in current block
will be overwritten !
to confirm
to cancel
IDENTIFICATION
COPY A BLOCK
DELTE A BLOCK
DELETE ALL BLOCKS
CHANGE PASSWORD
CHANGE LANGUAGE
RUN TIME
SET TO MIDPOSITION
CONVERGENCE MID
DYNAMIC ASTIGMATISM
MORE...