Blackline GPS Loner SMD - Manual (Page 18)

16 // USER GUIDE
About Checking In
Loner SMD can be configured in Loner Portal to have you periodically check in. During the
Check-in period, Loner SMD will enter the alarm mode and annunciate the low alarm pat-
tern to indicate a pending Missed Check-in alert. If you do not require assistance, you have
30 seconds to cancel the alert.
Cancelling a Pending Missed Check-in Alert:
1. Press the acknowledge button for 1 second.
After one second, the alarm pattern will be silenced and Loner SMD will return to
regular operation.
™ If you have not cancelled the alert within 30 seconds, the Missed Check-in Alert is sent,
initiating the alert escalation process. Loner SMD will annunciate the high alarm pattern
until the alert is cancelled or the battery is depleted.
Cancelling a Missed Check-in Alert
1. Press and hold the acknowledge button for 3 seconds.
After three seconds, the alarm pattern will be silenced and Loner SMD will return to
regular operation.
™ If the user cancels a Missed Check-in Alert, this does not clear the alert within the Loner
Portal user account. Monitoring personnel are required to address the safety incident.
Low Battery Detection
Loner SMD monitors the battery level of the device. If the battery level drops below 10%
of battery capacity, a Low Battery Alert will be sent and Loner SMD will annunciate the low
battery alarm pattern.
Loner SMD will continue all of the alarms until one of the following occurs:
Loner SMD is powered off;
Loner SMD automatically shuts down with a depleted battery;
Loner SMD is plugged in for charging.
™ Loner SMD sends a Loner SMD Powered Off by Low Battery message to the Loner
Backgroud Services before finally powering off.
™ If Loner SMD powers off with low battery, it will annunciate with a three second beep,
vibrate and indicator light array flash.