Blackline GPS Loner SMD - Manual (Page 16)

14 // USER GUIDE
Initiating an Emergency Alert (Emergency Latch Use)
If you are in an emergency situation, perform the following:
1. Open the Emergency Latch.
Loner SMD will instantly send an Emergency Message to Loner Background
Services. Loner SMD will annunciate the high alarm pattern to notify others nearby
of the event.
™ The alarm pattern on Loner SMD will continue until the Emergency Alert has been
canceled or the battery is depleted.
™ Another Emergency Alert will not occur until the Emergency Alert has been canceled.
Canceling an Emergency Alert (Emergency Latch Use)
1. Return the Emergency Latch to the closed position.
2. Press and hold the Acknowledge Button for 3 seconds.
After three seconds, the alarm pattern will be silenced and Loner SMD will return to
regular operation.
™ If the user cancels an Emergency Alert, this does not clear the alert within the Loner
Portal user account. Monitoring personnel are required to address the safety incident.
Initiating a Silent Emergency Alert
If you are in an emergency situation where you would prefer to not alert others in the area
(a silent emergency), perform the following:
1. Push and hold the acknowledge button for 5 seconds.
Loner SMD will vibrate for 3 seconds, pause and then vibrate for 2 more seconds. A
Silent Emergency Message will be sent to monitoring personnel.
™ Loner SMD will NOT annunciate the alarm pattern (it will remain silent).
™ Loner SMD will return to normal operation. You are not required to cancel the Silent
Emergency. Monitoring personnel are required to address the safety incident.
Motion/Activity Monitoring
Loner SMD is constantly monitoring your motion. If Loner SMD has not detected motion
for two minutes, it will enter the alarm mode and annunciate the low alarm pattern to
indicate a pending No-motion alert. If you do not require assistance, you have 30 seconds
to cancel the alert.