Blackline GPS Loner SMD - Manual (Page 12)

10 // USER GUIDE
Charging Loner SMD
1. Plug the Wall Charger into an electrical outlet.
2. Insert the Micro USB Cable Plug into the corresponding Micro USB Charging Jack
on the charging clip ensuring the USB symbol on the cable faces the flat
side of the charging clip. Note: Different cables may have the USB symbol on the top or
bottom of the connector. Care must be used to ensure the Micro USB cable plug is cor-
rectly connected to the charging clip.
3. Slide the charging clip onto Loner SMD using the guides to align the clip with the
charging port on the device.
4. Completely charge Loner SMD for 6 hours.
5. Remove the charging clip from Loner SMD.
Charging state can be determined by observing the charging light. See the section
Loner SMD Light Behaviour for more detailed information.
™ Charging Loner SMD will turn the device Off ensuring it will not trigger alerts while
charging.
™ Blackline GPS recommends charging Loner SMD after each shift to ensure the device is
fully charged for the next shift.
Turning Loner SMD On
1. Press the Power Button to turn Loner SMD on.
The beeper, alarm status light and vibration motor will annunciate the chirp pat-
tern. The power button indicator light will blink as Loner SMD connects to the
wireless network. While Loner SMD retains a wireless connection, the power button
indicator light will remain on.
Loner SMD needs to have sufficient battery power to connect to the wireless network.
Connection takes approximately one minute.
™ If Loner SMD fails to connect to the wireless network, the device will enter the no com-
munication alarm pattern.