Bird Technologies 5010 Series-Manual - Manual (Page 18)

6
z For Models 5014:
Connect the Bird DPS to the “Sensor” USB
port on the DPM using the sensor cable
provided.
z To connect to a PC with VPM2 software (5014
ONLY):
z
Connect the Bird DPS to the a USB port on
the PC using the sensor cable provided.
2. Connect the DPS to the RF line so that the arrow
on the sensor points towards the load, see “Ele-
ment Orientation” on page 2.
Note:
The arrow on the forward element
should point towards the load.
Note:
The arrow on the reflected element
should point towards the source.
Note:
Both elements must be either APM/
DPM or 43 types, do not mix elements.
3. Set the power on the DPM to the forward ele-
ment’s power rating.