Bird Technologies AT100 - Manual (Page 22)

Bird AT-100 Antenna Tester
12
Return to Factory Presets
When the Antenna Tester is turned on, the various software
parameters will be set to the condition they were at when
the tester was turned off.
To return the parameters to the factory setting follow the
steps below.
y The parameters will be set to the conditions listed below.
y Press the MENU key.
y Press the UTIL key.
y Press the PRESET key.
Software Parameter Factory Setting
Mode Swept Frequency
Start 2.0MHz
Stop 136.0MHz
Measurement Units VSWR
Scale min. 1.0; max. 5.0
Sweep Type Continuous
Limit Value 1.5
Limit Audio ON
Baud Rate 9600
Auto Shut-off Timer 5
Audio ON
Cursor 67MHz