Bird Technologies 8833-300 - Manual (Page 10)

Place the unit on its back, with the connector end
up. This position prevents coolant spillage.
Remove the clamping band by loosening the 10-32
x 1-1/2 inch screw on the clamping band.
Slowly lift the load resistor assembly out of the tank
allowing the coolant to drip back into the tank.
Check that the o-ring seal is in good condition, free
of twists, and positioned evenly all around the bev-
eled flange of the resistor housing. If the condition is
questionable, or coolant has leaked around a se-
curely-tightened clamping band, install a new o-ring
seal.
5.4 Installing the Load Resistor
Reverse the procedure described in paragraph
5.3.1—Removing the Load Resistor.
Tighten the clamping band securely, ensure the band
is fully seated, retighten the clamping band screw.
TO-nnn-nn-nnn-nn
Page 10