Bennett Marine Auto Tab Control - Manual (Page 4)

For Boat Leveler Insta-Trim Systems
The Auto Tab Control installation instructions are based on Bennett Trim Tab wire
colors. If you are installing the Auto Tab Control on a Boat Leveler system, the
wire color conversion is as follows:
Bennett RED wire = Insta-Trim GREEN wire •
Bennett GREEN wire = Insta-Trim WHITE wire •
Bennett Blue wire = Insta-Trim RED wire •
Bennett YELLOW wire = Insta-Trim YELLOW wire •
FAILURE TO COMPLY WITH ITEMS 1 AND 2 ON PAGE THREE WILL CAUSE
THE AUTO TAB CONTROL TO FUNCTION IMPROPERLY
If you have any questions regarding items 1 and 2 contact Bennett Marine by
e-mail at [email protected] or call Bennett Marine Client Services at
(954) 427-1400 (8:00 a.m. - 5:00 p.m. Eastern time, Monday through Friday).
SECTION 3
USING THE AUTO TAB CONTROL FOR THE FIRST TIME
How to Set the Zero Point. IMPORTANT NOTE: The ATC won’t turn on or
function correctly until you’ve set the “Zero Point.” (If the Zero Point has not been
set, the blue Set Zero light will flash.)
Setting the Zero Point. After installing the system, take your boat for a test run.
When underway, use the manual trim tab control to get your boat running at the
best running attitude. Press and hold both “Set Zero” buttons (Sun and Moon
Buttons) on the ATC Keypad (about 4 seconds) until the blue LED flashes rapidly.
After the LED is flashing, release the buttons. Your boat’s attitude is now set in the
memory.
NOTE: The system automatically turns off as soon as you’ve set the Zero
Point and released the buttons.
TIP: If you cruise within a wide range of running speeds (Example: 20 to 40 mph)
you should set the Zero Point within the lower half of the running range.
4