Bendix Commercial Vehicle Systems VORAD EVT-300 DRIVER INSTRUCTIONS - Manual (Page 19)

Driver ID Card (Optional)
Driver Identifi cation Card
If the system confi guration requires a Driver Identifi cation Card, (see Figure 10), it
must be inserted into the slot provided on the front of the Driver Display Unit (see
Figure 8, page 13). After the system is powered on, insert the Card into the slot with
a smooth, steady, continuous motion. Allow approximately one (1) second to ensure
the bar code is read. A high-pitched confi rmation tone will sound when the card
is correctly scanned. The card should be removed and stored in a safe place until
required again. If the bar code is not scanned correctly, the system will sound one
low-pitched tone.
If the Card is not installed into the slot in the Driver Display Unit, when required, two
events can occur: the green “ON” light will fl ash continuously; or the green “ON”
light will fl ash continuously accompanied by a matching audible tone. This is a
confi gurable option.
Driver Identifi cation Card (Optional)
15
Figure 10