Bendix Commercial Vehicle Systems VORAD EVT-300 DRIVER INSTRUCTIONS - Manual (Page 13)

Driver Display Indicators
Driver Display Indicators
9
Item Description
Green, Power-On/
Driver’s Identifi cation
Card Status* Illuminates after power is applied to the system and the
power-on self test (described on page 16) is complete.
The green “ON” light may blink continuously if the
Driver’s Identifi cation Card is not installed, (the Driver
ID Card is an optional feature) and card alarm might be
enabled*. (See Figure 5)
Volume Control* and
Power On/Off When pushed in until a distinctive click is heard and/
or felt, this turns the power on or off* if enabled.
Adjusts the volume of the Driver Display Unit speaker
if enabled. Activates “Failure Display Mode” when the
knob is pressed in and held for eight (8) seconds and
then released. (See Figure 5)
Speaker Located under the top cover of the Driver Display Unit.
Sounds audible tones to alert the driver of a possible
hazard. May be set to limit the volume to a minimum
level*. (See Figure 5)
Figure 5
FAIL
ON S/C
Warning Level Range Volume
Green, SmartCruise/Accident
Reconstruction
Light Sensor
Red
Orange
Yellow
Driver
Identification
Card Slot
Red, System
Failure
Green,
Power ON/
Driver Identification
Card Status
Volume Control
Power ON/OFF
Speaker
Range Control/
Accident Recorder
NOTE: Items marked with an asterisk (*) can be changed (confi gured), by a
Technician, by using ServiceRanger 2.8, a PC-based service support tool.