Adaptive cruise control configuration error, Overview, Diagnostic trouble code (dtc) detection – Bendix Commercial Vehicle Systems VORAD VS-400 INSTALLATION NOTES User Manual
Page 26: Symptom, Possible causes

General Information
24
Diagnostic Trouble Code (DTC)
Isolation Procedures
Component Code: 25
(SA 42, SPN 898, FMI 13, 14)
SmartCruise
®
Adaptive Cruise Control Configuration Error
Overview
This code indicates that the VS-400 Forward Looking Radar (FLR) has detected a SmartCruise configuration or compatibility issue with the
engine .
Diagnostic Trouble Code (DTC) Detection
At power up, the FLR attempts to verify if the engine controller is SmartCruise
®
adaptive cruise control compatible and has its Adaptive
Cruise Control (ACC) setting(s) enabled . If the FLR determines that one of these conditions is false, this Diagnostic Trouble Code (DTC) is
set .
•
Code 25, FMI 13 - Engine is not configured for SmartCruise
®
adaptive cruise control .
•
Code 25, FMI 14 - Engine ID is not recognized as SmartCruise
®
adaptive cruise control compatible .
Symptom
When this code is active, the Bendix
™
VORAD
®
VS-400 Collision Warning will continue to operate, but the Bendix
™
SmartCruise
®
adaptive
cruise control will not . The DIU will indicate SmartCruise
®
adaptive cruise control is not operational and the orange DTC light will be
illuminated .
Possible Causes
•
FMI 13 - The engine controller setting for Adaptive Cruise Control is not enabled.
•
FMI 14 - The engine does not support the Adaptive Cruise Control function or is not compatible with the VS-400 system.