Bendix Commercial Vehicle Systems ADB22X-V Air Disc Brakes - Manual (Page 30)

30
5.6.2 Remove the wheel. Refer to the vehicle manufac-
turer’s recommendations.
5.6.3 Remove the brake pads. See Section 5.2.
5.6.4 In most cases, the actuator should be removed. See
Section 5.4. In the case of spring brake actuators,
they should be caged before removing the brake
assembly.
5.6.5 In nearly all cases, the air disc brake caliper/carrier
will need to be removed from the vehicle in order to
complete this procedure. See Section 5.3.
5.6.6 Place the brake on a workbench and, using a vice,
secure it by the carrier.
5.6.7 Use a small chisel or similar tool to punch a hole
close to the center of the guide pin cap (10) of the
short guide pin, taking care to only insert the chisel
a small amount. Using the hole just made, pry the
cap off and discard. See Figures 63-65.
FIGURE 63 - PUNCH GUIDE
PIN CAP (10) FIGURE 64 - GUIDE PIN CAP
(10) HOLE
FIGURE 65 - PRY TO
REMOVE GUIDE PIN CAP (10) FIGURE 66 - USING SMALL
CHISEL TO REMOVE GUIDE
PIN CAP (68)
5.6.8 Remove the other cap (68) that covers the long
guide pin, by using a small chisel and hammer to
apply light blows to the cap, with the chisel aimed
away from the casting. See Figure 66. Discard
both caps.
Bendix
Number/
Ken-Tool
Number
Description Typical Tool View
Bendix
Number/
Ken-Tool
Number
Description Typical Tool View
T05 / KT05 1-3/8 in. diameter disc T14 / KT14 Brass nut
T06 / KT06 1-1/2 in. diameter disc T16 / KT16 Dimpling tool
T07 / KT07 2 in. diameter sleeve T20 / KT20 8 in. bolt
T08 / KT08 2-1/8 in. diameter disc T21 / KT21 Half sleeve
T10 / KT10 8 in. bolt T26 / KT26 Cap installation tool
T12 / KT12 3-7/8 in. long sleeve T27 / KT27 Cap installation tool
T13 / KT13 10 in. bolt
TABLE 6 - BENDIX ® ADB22X ™ AIR DISC BRAKE GUIDE PIN
AND SEALS REPLACEMENT TOOLS. (A WASHER IS ALSO
INCLUDED)