Baumfolder Flexifold: 1st Station (in 2004) - Manual (Page 32)

TP10494 PAGE 32
NOTE: If a button is not pressed within 2
minutes the machine will return
to the operating mode.
12.0 FOLDER OPERATION
12.1 Time
The “TIME” button will display the time since the
last total count reset and the total hours that the main drive
has been on, the customer can not reset this meter.
Both hour meters will increment only when the folder
is running. The pump operation or the main power will have
no affect on these meters.
NOTE: Every time the total count is reset the
job run time should also be reset.
Pressing the “TIME” button will change the display
to the time mode. In this mode the first line of the display
will show job run time and have a 4 digit capability to show
the number of hours since last reset. The second line will
show total hours and have a 6 digit capability to show the
total hours on the machine.
The “COUNT” button can be used to go back into the
count screen from the rate screen.
12.2 START/STOP button
In the normal operating mode pressing the “START/
STOP” button will activate the main drive motor and the
LED in the button will come on. Pressing the “START/
STOP” button again will deactivate the main drive motor
and turn off the LED.
12.3 PUMP button
In the normal operating mode pressing the “PUMP”
button will activate the pump motor, and the LED in the but-
ton will come on. Pressing the “PUMP” button again will
deactivate the pump motor and turn off the LED.
JOB RUN TIME ####
TOTAL HOURS ######
TOTAL COUNT #######
BATCH ### #####