Baumfolder Flexifold: 1st Station (in 2004) - Manual (Page 28)

TP10494 PAGE 28
When the “ENTER” button is pressed, the fold plates
and stacker will move to their new position. While the
motor(s) are running, a PLEASE WAIT message will be
displayed.
When the motors have stopped, one of two screens
will be displayed.
If the sheet length data was changed, the single sheet
mode screen is displayed.
If the sheet length data was not changed, the count
screen will be displayed.
Method 2: Entering Sheet Length first:
Setup a new job by pressing the “SHEET MODE”
button. The Sheet Length screen will be displayed showing
the last set sheet length. You have the following options:
· 1.) Enter a new sheet length.
Note: Pressing the enter button will accept the
new data and eliminate any waiting time
before moving to the next function.
After 5 seconds the data will be accepted and the last
fold type indicator will start flashing. Select the desired fold
type by pressing the appropriate “FOLD TYPE” button.
After 5 seconds the selection will be accepted and the fold
plate stops will move to their new position. During this
period the “PLEASE WAIT” screen will be displayed.
When the folder has completed its movement, the single
sheet mode screen will be displayed. At this point, each
time the “SHEET START” button is depressed
a single sheet will be folded and delivered. Any adjustments
to fold lengths or slitter shaft accessories may be made at
this time.
Press the “SHEET MODE” button to return to the
production mode. The count screen will be displayed.
·
PLEASE WAIT
SINGLE SHEET MODE
SHEET LENGTH ##.##
PLEASE WAIT
SINGLE SHEET MODE
TOTAL COUNT #######
BATCH ### #####
TOTAL COUNT #######
BATCH ### #####