Bang & Olufsen BeoTime - User Guide - Manual (Page 8)

Daily use
Switch the alarm on and off
and operate connected Bang &
Olufsen equipment and
compatible light control
systems.
For information on how to set
an alarm time, refer to page 11
in this guide.
Switch the alarm on and off
> Press the alarm button to
activate the alarm function.
> Press again to deactivate the
alarm function.
Snooze the alarm
You can snooze the alarm sound
either by:
– Touching the alarm clock and
thereby activate the motion sensor
function,
– Or pressing any buttons on the
navigation panel.
The alarm will continue with
intervals of 10 minutes, unless
playback has been allowed to
elapse three times in a row, after
which the alarm will be cancelled
until the next day.
Select and switch on a source
> Press from idle mode to enter
the menu in Display 1.
> Press or to select ‘SOURCE’.
> Press or to enter Display 2
> Press or to select the source
you wish to switch on.
> To switch on the source and
leave the menu, press while
Display 2 is selected.
> To leave the menu without
switching on the source, press
or to go to Display 1 and
press .
Switch off a source …
> Press from idle mode to enter
the menu in Display 1.
> Press or to select ‘SOURCE’.
> Press or to enter Display 2.
> Press or to select the source
you wish to switch off.
> Press or to enter Display 3.
> Press to switch off the source
and leave the menu.
You can switch off all connected
sources if you press and hold for
more than one and a half seconds.
If you hold down the button for
more than three seconds, the lights
will also be switched off.
8