Bang & Olufsen BeoTime - User Guide - Manual (Page 16)

Set up the alarm clock
The alarm clock is designed to
be placed either on a table or in
a magnetic wall bracket, so it can
easily be picked up.
The alarm clock must be placed
in a position from where all
Bang & Olufsen products it shall
control are visible.
Cautions
– Make sure that the product is
placed in accordance with the
instructions in this Guide. To
prevent injury, use Bang &
Olufsen approved accessories
only!
– Do not attempt to open the
product. Leave such operations
to qualified service personnel!
– The product is designed for
indoor use in dry, domestic
environ ments only, and for use
within a temperature range of
10–40˚ C (50–105˚ F).
– Do not place the product in
direct sunlight, as this may
reduce the sensitivity of the IR
transmitter.
Before you install the wall
bracket …
Test to see if there is a connection
between the alarm clock and your
Bang & Olufsen audio and video
products and lights.
> Switch on the products and
lights which the alarm clock
should control.
> Hold the alarm clock
approximately where you want
to install the wall bracket.
> Press and hold for three
seconds. If all products and
lights are switched off after
three seconds, there is a
connection between the alarm
clock and the products and
lights.
16