Bang & Olufsen BeoLab 10 - User Guide - Manual (Page 9)

To attach the loudspeaker front
panel
1 Insert all the little pegs on the
rear side of the panel into the
corresponding holes in the loud­
speaker cabinet.
2 Make sure that all the pegs are
firmly seated into the holes.
When finished, the loudspeaker
front panel must be aligned with
the front of the television screen. If
it apppears not to be so, remove
the loudspeaker front panel again,
and adjust the front­to­back
position of the loudspeaker.
To remove the front panel, for
example for cleaning, just pry the
little pegs free from the loud­
speaker cabinet.
Cover plates: If your loud¬speaker
is set up beneath a 65­inch screen,
fasten two cover plates to the wall
bracket – one on each side of the
bracket.
Ч 2