Bang & Olufsen BeoLab 10 - User Guide - Manual (Page 6)

Set up the loudspeaker – wall bracket
The wall bracket must be
fastened to the wall so that the
loudspeaker is placed in a
centred position immediately
below the television screen.
We recommend that you place the
television screen so that the loud­
speaker will be at least 10 cm (4")
above the floor.
About screws, washers and
wall anchors
Use the correct size and type of
screws, washers and wall anchors –
taking into account the
construction and condition of the
wall.
Use at least four screws – two in
each side of the wall bracket.
Under each screw head use an
appropriatly sized washer with a
minimum thickness of 1.6 mm
(0.07"). Each screw and washer
must have a minimum load rating
of 16 kg (35 lbs).
Additional notice about light
partition walls:
If you intend to hang the loud­
speaker on a gypsum wall (also
known as drywall or wallboard),
the wall bracket must be fastened
to a vertical stud! Mounting was
evaluated for use on a drywall
surface.
Use one round­headed lag screw
(ø 6 mm – 0.23"), which
penetrates the gypsum and is
screwed a minimum of 25 mm (1")
into a vertical stud. Furthermore,
use three additional screws of a
type intended for gypsum walls.
≥ 10 cm
4"
≥ 59 cm
23"
6