Bang & Olufsen BeoLab 10 - User Guide - Manual (Page 7)

To fasten the wall bracket
1 Fold the cardboard ‘tool’ as
shown, and attach it to the wall
bracket.
2 Hold the wall bracket against the
wall – centred below the tele­
vision screen. Make sure that the
‘tool’ touches the screen edge.
3 Mark up on the wall where to
drill the holes.
4 Drill the holes in the wall, and
insert the appropriate wall
anchors.
5 Fasten the wall bracket to the
wall using the appropriate size
and type of screws and washers.
The holes in the wall bracket allows
for some adjustment. Make sure
that the wall bracket is in the
correct position – level and centred
in the correct distance from the
screen edge. Then fully tighten all
the screws.
62 mm
2.44"
7
Cardboard ‘tool’: The ‘tool’ is used as a help to position the wall
bracket in the correct distance from the lower edge of the television
screen.