Balboa Water Group MLM990S - Manual (Page 10)

10
MESSAGE MEANING
Power has been cut off to the spa.
Heater Overheat
º"ÛiÀ i>М»К‡К/ iКГ«>Ê >ГКГ ХМК`œЬ˜. 1
On some systems, an alarm may sound.
"˜iʜvÊÌ iÊÃi˜ГœАГК >ÃÊ`iÌiVÌi`Ê££ncÊ
­>««АœЭˆ“>МiЮК{З°nc®Ê>ÌÊÌ iÊ i>ÌiÀ°
º"ÛiÀ i>М»К‡К/ iКГ«>Ê >ГКГ ХМК
down.
1 One of the sensors has
`iÌiVÌi`ÊÌ >ÌÊÌ iÊë>ÊÜ>ÌiÀʈÃÊ££дcК
­>««АœЭˆ“>МiЮК{О°Оc®°
ºVi»К‡К*œМi˜Мˆ>ÊvÀiiâiÊ
condition detected.
-«>КˆГКГ ХМК`œЬ˜. 1 The sensor that
ˆГК«Х}}i`Кˆ˜МœКМ iК-i˜ÃœАКº»К>VŽКˆГК
˜œМКЬœАŽˆ˜}°
-«>КˆГКГ ХМК`œЬ˜. 1 The sensor that is
«Õ}}i`Кˆ˜МœКМ iК-i˜ÃœАКº »К>VŽКˆГК
˜œМКЬœАŽˆ˜}°
-i˜ГœАГК>АiКœХМКœvКL>>˜Vi°
-i˜ÃœÀÊv>ˆХАi°К/ iКГ«>КˆГКГ ХМК`œЬ˜° 1
ÊÃÕLÃÌ>˜Ìˆ>Ê`ˆvviÀi˜ViÊLiÌÜii˜ÊÌ iÊ
temperature sensors was detected.
This could indicate a flow problem.
*iÀÈГМi˜МКœЬКvœЬК«АœLi“Г°К­ˆГ«>ЮГК
œ˜КМ iКvˆvМ КœVVÕÀÀi˜ViʜvÊÌ iʺ
Heater
œЬКœЬ »К“iГГ>}iКЬˆМ ˆ˜КУ{К œХАГ°®К
Heater is shut down, but other spa
functions continue to run normally.
Inadequate water detected in heater.
ACTION REQUIRED
The control panel will be disabled until power returns. Time
œvÊ`>ÞÊ܈ÊLiÊ«ÀiÃiÀÛi`КvœАКОдК`>ЮГКЬˆМ К>ÊL>ÌÌiÀÞÊL>VŽ‡Х«Кœ˜К
näääÊÃÞÃÌi“Г°К
£дддК>˜`ÊܓiÊ
ÓäääÊÃÞÃÌi“ÃÊÀiÃiÌÊÌ iК
Мˆ“iКœvК`>Þʜ˜Êi>V Ê«œЬiА‡Х«°К-«>ÊÃiÌ̈˜}ÃÊ>ÀiÊ«ÀiÃiÀÛi`Кœ˜К>Ê
systems.
"К "/К
/
,К/
К7/
,°К,i“œÛiÊÌ iÊë>ÊVœÛiÀÊ>˜`Ê>œЬК
Ь>ÌiÀÊ̜КVœœ°К"˜ViÊÌ iÊ i>ÌiÀÊ >ÃÊVœœi`]ÊÀiÃiÌÊLÞÊÕȘ}Ê>Ê>ÃÌÊ
Key. If spa does not reset, shut off the power to the spa and call
your dealer or service organization.
"К "/К
/
,К/
К7/
,°К,i“œÛiÊÌ iÊë>ÊVœÛiÀÊ>˜`Ê>œЬК
Ь>ÌiÀÊ̜КVœœ°КМК£дЗcК­>««АœЭˆ“>МiЮК{£°Зc®]КМ iКГ«>КГ œХ`К
automatically reset. If spa does not reset, shut off the power to
the spa and call your dealer or service organization.
No action required. The pumps and the blower will automatically
activate regardless of spa status.
If the problem persists, contact your dealer or service
œÀ}>˜ˆâ>Мˆœ˜°К­>ÞÊ>««i>ÀÊÌi“«œÀ>АˆЮКˆ˜К>˜ÊœÛiÀ i>МКГˆМХ>Мˆœ˜К
and disappear when the heater cools.)
If the problem persists, contact your dealer or service
œÀ}>˜ˆâ>Мˆœ˜°К­>ÞÊ>««i>ÀÊÌi“«œÀ>АˆЮКˆ˜К>˜ÊœÛiÀ i>МКГˆМХ>Мˆœ˜К
and disappear when the heater cools.)
This may just be a temporary condition, and may clear itself.
œ˜Ì>VÌÊޜÕÀÊ`i>iÀʜÀÊÃiÀۈViКœА}>˜ˆâ>̈œ˜°
iVŽÊÜ>ÌiÀʏiЫiКˆ˜КГ«>°Ê,ivˆÊˆvʘiViÃÃ>АЮ°КvКМ iКЬ>ÌiÀʏiЫiК
ˆГКœŽ>Ю]К“>ŽiÊÃÕÀiÊÌ iК«Х“«ГК >ÛiÊLii˜К«Аˆ“i`°Кˆ} ˆ} МКМ iК
message and press
to reset.
œœÜÊ>V̈œ˜ÊÀiµÕˆÀi`ÊvœÀʺ
Heater Flow Low »Ê“iÃÃ>}i°Ê
iVŽÊÜ>ÌiÀʏiЫiКˆ˜КГ«>°Ê,ivˆÊˆvʘiViÃÃ>АЮ°КvКМ iКЬ>ÌiÀʏiЫiК
ˆГКœŽ>Ю]К“>ŽiÊÃÕÀiÊÌ iК«Х“«ГК >ÛiÊLii˜К«Аˆ“i`°Ê7ˆÊÀiÃiÌÊ
automatically after 15 minutes, or highlight and press
.
Spa Overheat
Freeze Condition
Sensor A
Fault
Sensor B
Fault
Sensor Sync
Sensor Sync Fail
Heater
Flow Low
Low Flow
Heater May
Be Dry
Diagnostic Messages
No Message
on Display
1 On some systems even when spa is shut down, some equipment may occasionally turn on to continue monitoring temperature
or if freeze protection is needed.