beautypg.com

Specifications, Troubleshooting – Balboa Water Group Dolphin II CE User Manual

Page 32

background image

32

SPECIFICATIONS

Remote Control Power

2 AA Batteries

IR Command Center Power

120 VAC

IR/Visual Equipment Range *

Up to 30 Feet (7.62 m) ± 30°

Remote Control Dimensions (H x W x D)

9-2⁄16 x 2-10⁄16 x 1-3⁄16 in.
232 x 65 x 31 mm

Remote Control Weight (without
Batteries)

8 oz (220 g)

NOTE: Specifications are typical. Individual units
may vary. Specifications are subject to change
and improvement without notice.

* Distance may vary

TROUBLESHOOTING

PROBLEM: LED does not blink when you press a key.
SOLUTION: Replace the batteries with two (2) new AA

alkaline batteries (see page 7).

PROBLEM: LED blinks when you press a key, but

home entertainment component does

not respond.

SOLUTION: Make sure you are aiming the Dolphin at

your home entertainment component and

that you are within 15 feet of the

component you are trying to control.

PROBLEM: The Dolphin does not control home

entertainment components or commands

are not performing properly.

SOLUTION: Try all listed codes for the component

brand being set up. Make sure all

components can be operated with an

infrared remote control.

PROBLEM: TV/VCR combo does not respond properly.
SOLUTION: Use the VCR codes for your brand. Some

combo units may require both a TV code

and a VCR code for full operation (see

pages 8-15).

PROBLEM: No volume on a second TV.
SOLUTION: Follow instructions in Changing Volume

Lock (see page 28).

PROBLEM: CH+ , CH– , and LAST do not work for

your RCA TV.

SOLUTION: Due to RCA design (1983-1987), only the

original remote control will operate

these functions.

PROBLEM: Changing channels does not work properly.
SOLUTION: If original remote control required

pressing ENTER to change channels, press

ENTER on the Dolphin after entering a

channel number.

PROBLEM: Tried “Search Method” and still could not

find a working code.

SOLUTION: Try the “Search Method” again after

clearing out the device key as follows:

Press and hold ENTER until red light blinks

twice, then release. Next enter 9 - 9 - 2.

Then press and release the device key to be

cleared twice.