Balboa Water Group Dolphin II CE - Manual (Page 26)

26
CHECKING THE CODES
If you have set up the Dolphin using the
“Searching For Your Code” procedure, you may
need to find out which four-digit code is operating
your equipment:
For example, to find out which code is operating
your TV:
1. Turn on your TV.
2. On the Dolphin, press and hold SETUP until the
LED blinks twice, then release SETUP.
3. Enter 9 - 9 - 0. The LED will blink twice.
4. To view the code for the first digit, press 1
once. Wait 3 seconds and count the number of
LED blinks (e.g., 3 blinks = 3) and write down
the number in the left most TV Code box below.
NOTE: If a code digit is “0”, the LED will
not blink.
5. Repeat step 4 three more times for remaining
digits. Use 2 for the second digit, 3 for the third
digit, and 4 for the fourth digit. Finish writing
down the code in the TV Code boxes below.
6. To check for the codes of your other
components, repeat steps 1 through 5, but
substitute the appropriate key (i.e., VCR,
CBL/SAT, DVD, CD or RCVR) for the component
you are checking. Write down the codes in the
appropriate boxes below.
TV Code
QQQQ
VCR Code
QQQQ
CBL/SAT Code
QQQQ
DVD Code
QQQQ
CD Code
QQQQ
RCVR Code
QQQQ