Ambient ACL 203 - Manual (Page 4)

3
Dip switches behind USB connector:
There are 4 dip switches behind the USB connector:
Nr. Description 0 / Off (up) 1 / On (down)
1 LTC-In Mode Set Time Code Insert Userbits
2 Battery voltage ref. see below
3 Battery voltage ref.
4 Not assigned
Battery voltage reference:
dip switch 2 dip switch 3 battery type threshold
0 / Off 0 / Off alkaline 2,2 Volts
0 / Off 1 / On NiMH rechargeable 2,4 Volts
1 / On 0 / Off Lithium battery 2,5 Volts
1.2: Examples for typical settings:
Europe SW1 SW2 SW 3 USA SW1 SW2 SW3
PAL 25 0 2 2 NTSC 29.97 0 3 3
HD 720/50P 1 5 2 HD 720/59.94P 1 6 3
HD 1080/24P 3 1 1 HD 1080/23.98P 3 0 0
WC 48K/25 fps 5 2 2 WC 48K/30 fps 5 2 4
AES-3 48K/25 fps 8 2 2 AES-3 48K/30 fps 8 2 4
1.3 LED Indicators
Upon boot, first one, then both LEDs will light up. Then the red LED will double
flash until the PLL is locked and sync signal is being generated. The LED will
flash in seconds pulse then.
When jamming, the red LED will stop flashing, the green LED starts double-
flashing. After 2 – 3 seconds, it will go into the normal “flash once per second”
mode.
Warnings:
Fast flashing red : Invalid setting selected.
Fast flashing green LED: Unit is in “recovery” mode.
Alternating fast red / green LED: Software or hardware error.
Double flash every 2 seconds: battery voltage below selected threshhold (see 1.1)