Bosch Maxx WTL 6500 - Manual (Page 47)

47
The dryer has been designed for 10 or 16 amperes.
0.
If the dryer fuse (factory setting) does not correspond
to the socket fuse (household fuse), complete the folĆ
lowing steps:
1. Connect the dryer to the mains electricity (see paĆ
ge 40).
2. Turn the programme selector to Off.
3. Simultaneously press and hold the Start/Stop and
Low Heat buttons.
4. Turn the programme selector clockwise to extra
dry".
5. Release both buttons.
6. Turn the programme selector 5 positions further
clockwise.
7. Press the Start/Stop button.
8. Press the Low Heat button (only if conversion is
necessary).
i
The value set (10 or 16) will be shown in the DisĆ
play.
i
If no value is shown: switch off the dryer and start
again.
9. Press the Start/Stop button. The value is stored
and the display goes out.
10.Turn the programme selector to Off.
Converting the
installed load