Bosch Maxx WTL 6500 User Manual
Page 40
40
Caution:
The dryer must be connected correctly to an A.C.
contactor socket.
The mains voltage must comply with the voltage inforĆ
mation given on the identification plate (on the rear of
the unit).
The connected load and the necessary fusing are
shown on the identification plate.
The dryer can be modified to suit the existing fusing
(see page 47).
Ensure that:
- the plug and the socket are compatible.
- the wire crossĆsection is sufficient.
- the earth system is installed in accordance with
regulations.
If the mains cable needs altering, this should only be
done by the afterĆsales service.
Do not use multiple plugs/connectors and/or extenĆ
sion cables.
Only use currentĆoperated circuit breakers which are
marked as follows: 7.
Do not touch the plug with wet hands.
Always pull the plug grip to remove the plug from the
socket.
The dryer is delivered as a complete unit. The instrucĆ
tion manual and any special equipment ordered can
be found in the drum.
If required, the dryer can be adapted or added to
using separately available kits (see page 41 onwards).
Electrical
connection
Scope of delivery
Accessories