Bosch Maxx WTL 6500 - Manual (Page 34)

34
What to do if ...
d
Danger, electrical current.
Repairs must only be carried out by the afterĆsales
service or an authorised expert.
If you cannot rectify a fault yourself, or a repair is
necessary:
q Turn the programme selector to Off.
q Remove the plug from the socket.
q Contact the afterĆsales service (see page 37).
What to do if ... Cause Solution
The Start/Stop" indicator
l d
The dryer is not plugged in. Plug in the dryer. p
lamp does not come on.
The Start/Stop button has not been
pressed.
Press the button.
A fuse has blown in your home. Reset/change the fuse.
The dryer does not start. The Start/Stop button has not been
pressed.
Press the button.
The door and/or maintenance flap
are not closed properly.
Close the maintenance flap and the
door.
No programme has been set. Select the programme you require
using the programme selector.
The ambient temperature is below
5 ºC.
Increase the room temperature.
The Filter" indicator
l i fl hi
The filter is blocked. Clean the filter (see page 30).
lamp is flashing.
The condenser unit is clogged. Clean the condenser unit
(see page 32).
Check the installation conditions
(see page 39).