Bosch Maxx WTL 6500 - Manual (Page 35)

35
What to do if ... Solution Cause
The Filter" indicator
lamp is on even though
thfilt i f f fl ff
The filter is blocked. Rinse the filter with warm water, dry
it thoroughly (see page 30).
the filter is free of fluff.
The condenser unit is clogged. Clean the condenser unit
(see page 32).
The Conden. water" and
Start/Stop" indicator
The water container is full. Empty the container (page 31).
Start/Stop" indicator
lamps are flashing.
The water drainage hose is kinked. Unkink the hose.
There is water in the
water container overflow
cap.
The area between the overflow and
the overflow cap is blocked.
Wash out the container and the
overflow thoroughly with water.
One or more programme
status indicator lamps are
flashing.
There has been a fault in the
programme sequence or operation.
Clean the fluff filter and the
condenser unit (see pages 30
and 32). g
Check the installation conditions
(see page 39).
Switch off the dryer, let it cool and
then switch it on again. Restart the
programme.
The maximum drying time for the
programme has been exceeded.
Clean the fluff filter and the
condenser unit (see pages 30
and 32).
Check the installation conditions
(see page 39).
Spin the laundry in the washing
machine at the maximum spin
speed.
The humidity in the room
has increased
i ifi tl
The room is not sufficiently
ventilated.
Ensure sufficient ventilation.
significantly.
The ventilation grille is obstructed. Keep the ventilation grille clear.
The condenser unit has not been
inserted.
Insert the condenser unit.
Water is leaking out. The door and/or maintenance flap
seals are dirty or damaged.
Clean the seal or have it replaced
by the afterĆsales service.
The door opens by itself. The catch is not engaged. Push the door until you hear a click
as the locking catch engages.