Bunn AF PR-3 - Manual (Page 9)

9
FIG. 4 FUSE HOLDER
FUSE AND FUSE HOLDER
1
2 1
2
FL A FLA V OR OR
IN PU T INPUT
MI XE D P R
MIXED PR
OD UC T O UT PU T
ODUCT OUTPUT
2
1
1
2
3
3
3
W AT ER TER
IN PU T INPUT
RE FIL L REFILL
MA IN MAIN PO PO W ER WER
P1561
Location:
The fuse holder is located on the lower right
front of the autofill box just to the left of the power
cord.
Test Procedure:
1. Disconnect the dispenser from the power source.
2. Remove cap and fuse from fuse holder.
3. Remove fuse from the cap.
4. Check for continuity through the fuse.
If continuity is present as described, reinstall the fuse,
the fuse is operating properly.
If continuity is not present as described, replace the
fuse.
28791.1 011500
WHI/GRN from Main
Harness/ON/OFF Switch
WHI/GRN from Main
Harness/Control Board
BLK from Main
Wiring Harness
BLK to Main
ON/OFF Switch
FIG. 5 FUSE HOLDER TERMINALS
P1331
Removal and Replacement:
Fuse:
1. Remove the cap from the fuse holder.
2. Remove fuse from the fuse holder, inspect, if
blown discard.
3. Install new 10 amp fuse in the fuse holder.
4. Reinstall fuse holder cap.
Fuse Holder:
1. Disconnect the wires from the rear of the fuse
holder.
2. Remove the nut securing the fuse holder to the
front of the main mounting panel.
3. Push the fuse holder through the hole in the panel.
4. Install new fuse holder and fuse through the hole
in the panel.
5. Secure the fuse holder to the panel.
6. Refer to Fig 5 and reconnect the wires.
SERVICE