Agio International Rectangular Inlaid Glass Table - Manual

Page 2
MODEL # 553860-22-487
IMPORTANT!! PLEASE READ ENTIRE INSTRUCTION SHEET BEFORE ASSEMBLY!!
12
12
6
6
9 9
PARTS LIST DESCRIPTION
PVC NUT COVER
PVC BOLT COVER
HEX BOLT DRIVER
HEX WRENCH
WASHER
NUT
TOPSIDE SUPPORT
TABLE LEG
LEG CONNECTOR
BRACKET
TABLE RIM
GLASS TOP
QTY./PCS
8
8
1
1
16
8
2
4
1
1
1
1/4"x20MM BOLT
1/4"x25MM BOLT
6
2
1
2
3
4
5
6
7
8
9
10
11
12
13
13 12
8 7
9
9
Step 1:CAREFULLY remove glass and set aside until
Step 7. Lay glass flat--do not stand on edge.
Set parts on a flat, non-abrasive surface. Remove
all protective materials. Identify all parts packed
in carton against the parts list. If you are missing
any parts, or are unsure how to proceed with
assembly, call our Customer Service Center at
1-800-416-3511. Do not attempt to assemble the
table if any parts are missing or damaged.
Step2: Place the table rim (without glass) upside down
Attach a leg to the rim using a (1/4"x20mm)
bolt. Add a washer to bolt, then guide this into the
pre-drilled hole already in place in the table rim.
Hand tighten bolts. Repeat on the other three legs.
on a flat, non-abrasive surface to avoid scratching
the rim.
Important note: Hand tighten bolts only for this step.
Do not over tighten. Some adjustments may be
necessary to ensure table legs are aligned properly.
Step3:Attach a topside support to the rim using the
(1/4"x20mm) bolt. Add a washer to each bolt, then
guide into the pre-drilled hole in the table rim. Hand
tighten bolts. Repeat on the other side. Important note:
Hand tighten bolts only for this step. Do not over
tighten. Some adjustments may be necessary to
ensure table legs are aligned properly.
Step4:Attach a leg to the leg connector bracket by carefully
guiding the bolts already in place on the table legs (each
through the holes in the leg connector
bracket. Add a washer and a nut to the end of each bolt.
Hand tighten only. Repeat on other three legs.
leg has two bolts)
Step5:Using a (1/4"x25mm) bolt, attach a topside support
to the leg connector bracket. Add a washer to each bolt,
and guide this through the inside of the leg connector
bracket, and into the fixed nut already in place in the
topside support. Hand tighten only. Repeat for other side.
Step6:At this time, make any minor adjustments in the alignment
Each bolt must be tightened a few
revolutions at a time. In order to apply even pressure, we
of the table legs or topside supports. Once you have
legs and topside supports in the correct position, use the
Hex Bolt Drive and Hex Wrench provided to tighten all
nuts and bolts. Note:
recommend you alternate between nuts and bolts, working
in a cross corner (”X”) fashion. DO NOT OVER
TIGHTEN. Cover all nuts and bolts with PVC covers.
Step7:With the help of another person , turn the table in
the upright position. Note the clear bumpers spaced
CAREFULLY place the glass inside the rim, resting on
Your table is ready for use.
evenly throughout the inside of the table rim.
the clear bumpers.
If you have any questions, please call our customer
service department (800) 416-3511.