Agio International Rectangular Captured Glass Table User Manual
Agio International Furniture
30-3860-15
Page 2
PART LIST
DESCRIPTION
QTY./PCS
TABLE LEG
LEG CONNECTOR
BRACKET
TABLE RIM
WITH GLASS
BOLT
4
2
1
1
8
1
8
8
8
8
PVC BOLT COVER
WASHER
PVC NUT COVER
HEX BOLT DRIVER
NUT
HEX WRENCH
IMPORTANT!! PLEASE READ ENTIRE INSTRUCTION SHEET BEFORE ASSEMBLY!!
Step 1: Identify all parts packed in the carton
against the parts list. Remove all protective
materials. If you are missing any parts or are
unsure how to proceed with assembly, please
call our Customer Service Center immediately
at 1-800-416-3511. Do not attempt to assemble
the table if any parts are missing or damaged.
Step 2: With the help of another person, place tabletop
upside down on a flat, non-abrasive surface to
avoid scratching the glass and rim. Note the
nsert legs into
the plastic fittings of the rim.
plastic fittings on the inside of the table rim.
These fittings slide. Adjust, if necessary, by
sliding the fittings into proper position in the
corners as shown in diagram below. If applicable,
adjust the flat plastic supports so they are evenly
spaced between plastic fittings. I
Step 3:Attach leg connector bracket (begin with the leg
connector bracket closest to the table) by inserting
bolt through the table leg and leg connector bracket.
Secure bolt with nut. Hand tighten only (do not
fully tighten bolts at this time as some adjustments
may be necessary between the leg connector bracket
and the legs to ensure proper alignment of the table
legs). Repeat for remaining table legs. Repeat
procedure for remaining leg connector bracket.
Step 4: Tighten all nuts and bolts using the Hex Bolt
Driver and Hex Wrench provided. Important note:
each bolt should be tightened a few revolutions at
a time, alternating between bolts in a cross corner
(”X”) fashion. This will ensure your table is level
by placing equal pressure on all bolt joints. Do not
over tighten. Cover all nuts and bolts with
PVC covers provided.
Step 5: With the help of another person, carefully turn
the table in the upright position. Your table is now
ready for use. If you have any questions, please call
our Customer Service Center at1-800-416-3511.
Plastic Fitting