Agio International "Boat-shaped Inlaid Glass Table" - Manual

PARTS LIST DESCRIPTION
PVC NUT COVER
PVC BOLT COVER
HEX BOLT DRIVER
HEX WRENCH
WASHER
NUT
1/4" X 25MM BOLT
1/4" X 20MM BOLT
TOPSIDE SUPPORT
TABLE LEG
LEG CONNECTOR
BRACKET
TABLE RIM
GLASS TOP
QTY./PCS
8
8
1
1
16
8
2
6
2
4
1
1
1
MODEL # 55-40685-22-702
Page 2
A
B
C
D
E
F
G
H
I
J
K
L
M
IMPORTANT!! PLEASE READ ENTIRE INSTRUCTION SHEET BEFORE ASSEMBLY!!
G
L
I
I
H
M
F
F
L
L
I
I
Step3:Attach a leg to the leg connector bracket by carefully
guiding the bolts already in place on the table legs (each leg
has two bolts) through the holes in the leg connector bracket.
Add a washer and a nut to the end of each bolt. Hand tighten
3-4 revolutions only. Do not tighten completely. Repeat on
other three legs
Step4:Attach topside support to leg connector bracket using a
1/4” x 25mm bolt and a washer as shown in diagram. Guide
bolt with washer through hole in leg connector bracket, into
the pre-drilled hole in the topside support. Hand tighten 3-4
revolutions only. Do not tighten completely. Repeat for
opposite topside support.
Step5:After making any necessary adjustments to the alignment of
the table legs and the leg connector bracket, use the hex bolt
driver and hex wrench to tighten all nuts and bolts. Note:
each bolt must be tightened a few revolutions at a time. In
order to apply equal pressure to all bolt joints, we recommend
working in a cross corner (”X” fashion). Repeat until all
bolts are tight. Do not over tighten. Over tightening may
strip bolts. Cover all nuts and bolts with PVC covers.
Step6:With the help of another person, turn the table in the upright
position. Note the clear bumpers spaced evenly throughout
the inside of the rim. Carefully place glass inside the rim,
resting on the clear bumpers. Your table is now ready for
use. If you have any questions, please call our Customer
Service Center at 1-800-416-3511
Step1:Carefully remove glass and set aside until Step 6 . Lay
glass flat--do not stand glass on edge. Remove all
protective materials and set parts on a flat, non-abrasive
surface. Identify parts packed in carton against the parts
list. If you are missing an parts or are unsure how to
proceed with assembly, call our Customer Service Center
at 1-800-416-3511. Do not attempt assembly if any
parts are missing or damaged.
Step2:Place the table rim (without glass) upside down on a flat,
non-abrasive surface. Attach table leg to rim using a
1/4” x 20mm bolt and washer as shown in diagram.
Guide bolt through hole in table leg, into pre-drilled hole
in the table rim. Hand tighten 3-4 revolutions only. Do
not tighten completely. Some adjustments may be
necessary to ensure proper alignment of the table legs.
Repeat for other three legs. Attach topside supports with
1/4” x 20mm bolts and washers using same procedure.