3D Robotics X8 Plus - Manual (Page 7)

5
2 Unfold Legs
Remove the bolts and nuts to the inside of the folded legs (1),
unfold the legs, re-insert the bolts, and secure with the nuts (2).
3 Attach Propellers
The X8 uses SF and SFP propellers. These labels can be found on the
individual propeller packages and on the propellers themselves. See
the diagram below for which motors require SF or SFP propellers. The
accuracy of this assembly is critical for the X8 to fly correctly.
To attach each propeller, remove the nut and washer from the motor,
and add the correct type of propeller with the writing on the propeller facing
the sky. (This will be a tight fit; apply pressure and twist the propeller
onto the motor.) Replace the washer over the propeller, and tighten the
nut on top using the propeller wrench.
1
2
X8 Assembly: Unfold Legs
top motor: SF
bottom motor: SFP
bottom motor: SF
top motor: SFP
X8 Propeller Order
top motor: SF
bottom motor: SFP
top motor: SFP
bottom motor: SF
X8 Propeller Assembly
!
Ensure that the writing on all
propellers faces the sky.