Zero Gravity Honda CBR 250R (11-12) Windscreen - Manual (Page 4)

Honda CBR250R (11-13) DIY Windscreen Install
4
443-IS
SPORTBIKE SADDLES & WINDSCREENS
WWW.ZEROGRAVITY-RACING.COM
Pull forward to remove the front face with headlamp. It
should look like shown above. This step is to make PT3
easier to have access.
Front Fairing Headlamp Removal Access To Inner Front Face Fairing PT2
Cover your front fender with a cloth. Locate the two mir-
ror mounts on the upper fairing. Pull upper fairing up
and away to dislodge the two raised holes from the
metal bracket.
Front Fairing Headlamp Removal Access To Inner Front Face Fairing PT1
Pull up on
the fairing to
dislodge
from these
holes.
Remove two Big screws from the front face fairing and
headlamp. Location shown in OVERVIEW 1 of 2.
Front Fairing Headlamp Removal Access To Inner Front Face Fairing PT3
FFR RO ON NTT B BIIK KE E
Remove two Big screws from the side of the front face
fairing & headlamp assembly on either side of the bike.
Front Fairing Headlamp Removal Access To Inner Front Face Fairing PT3
FFR RO ON NTT B BIIK KE E
Q QU UIIC CK K IIN NS ST TA AL LL L T TIIP P
You can save alot of time and steps from here if you
have a 2nd helper to hold the front face fairing and
headlamp while you concentrate on unscrewing the
screws shown in OVERVIEW 1 of 2. You will be removing
Small screws from this front upper fairing. Shown in a
circle. After removing the small screws and bracket,
slide the windscreen up to dislodge. Install Zero Grav-
ity Screen, like your factory screen was installed in. If
this shortcut is taken skip to Page number 6.
Remove two Big screws attached from the front face fairing
and headlamp.
Front Fairing Headlamp Removal Access To Inner Front Face Fairing PT4