Zero Gravity Triumph Daytona 675 (2013) Windscreen - Manual

Pad Specs:
1/2” Square pad
x 1/8” Thick
Mounting Your Zero Gravity Windscreen
Remove both of the mirror fasteners located underneath the
mirror foot. Remove both of the mirrors. Remove factory
windscreen by unscrewing the four top allen screws. Re-
move four wellnuts, pulling them down from the bottom.
When removing the windscreen, pull towards the back
since it’s sandwiched in between two layers. BEFORE in-
stalling ZG’s windscreen on to the bike, apply vibration damp-
ing tape that is supplied in the ZG bag. To apply, adhere tape
in front of the step at the top of the marker light as shown. To install
the ZG windscreen, reverse the uninstall instruction sequence.
Note: For best results, clean surface of the substrate with alcohol, removing any sur-
face contaminant's such as dirt, dust, processing oils or waxes. Apply tape once the
surface is completely dry.
914v install
PLEASE READ BEFORE MOUNTING YOUR WINDSCREEN
TRIUMPH DAYTONA 675/R DIY WINDSCREEN INSTALL
Installation Manual for Triumph Daytona 2013 to Present Windscreen Install
Thank you for purchasing one of Zero Gravity’s windscreens which has been designed and manufactured to give years of safe and fun
riding. This instruction manual gives you an in-depth look at the
installation process. To receive further assistance or parts please call Zero
Gravity ® Sales Department at 805-388-8803 or e-mail at [email protected].
Helpful hints: Use metric tools, clean hands, and put the bike on a center stand. Do not pry on the screen excessively, as it will break
without much warning.
Apply tape in
front of the step
Locate the upper marker light
SPORTBIKE SADDLES & WINDSCREENS
WWW.ZEROGRAVITY-RACING.COM
Pad Specs:
1/2” Square pad
x 1/8” Thick
Mounting Your Zero Gravity Windscreen
Remove both of the mirror fasteners located underneath the
mirror foot. Remove both of the mirrors. Remove factory
windscreen by unscrewing the four top allen screws. Re-
move four wellnuts, pulling them down from the bottom.
When removing the windscreen, pull towards the back
since it’s sandwiched in between two layers. BEFORE in-
stalling ZG’s windscreen on to the bike, apply vibration damp-
ing tape that is supplied in the ZG bag. To apply, adhere tape
in front of the step at the top of the marker light as shown. To install
the ZG windscreen, reverse the uninstall instruction sequence.
Note: For best results, clean surface of the substrate with alcohol, removing any sur-
face contaminant's such as dirt, dust, processing oils or waxes. Apply tape once the
surface is completely dry.
914v install
PLEASE READ BEFORE MOUNTING YOUR WINDSCREEN
TRIUMPH DAYTONA 675/R DIY WINDSCREEN INSTALL
Installation Manual for Triumph Daytona 2013 to Present Windscreen Install
Thank you for purchasing one of Zero Gravity’s windscreens which has been designed and manufactured to give years of safe and fun
riding. This instruction manual gives you an in-depth look at the
installation process. To receive further assistance or parts please call Zero
Gravity ® Sales Department at 805-388-8803 or e-mail at [email protected].
Helpful hints: Use metric tools, clean hands, and put the bike on a center stand. Do not pry on the screen excessively, as it will break
without much warning.
Apply tape in
front of the step
Locate the upper marker light
SPORTBIKE SADDLES & WINDSCREENS
WWW.ZEROGRAVITY-RACING.COM