Zero Gravity Honda CBR 250R (11-12) Windscreen User Manual

Zero Gravity For motorcycles

Honda CBR250R (11-13) DIY Windscreen Install

443-IS

SPORTBIKE SADDLES & WINDSCREENS

Remove 2 sets of allen screws A & B.

Note:

One bolt

“A” is longer and has a step on the bottom shoulder.

Here’s the retention clips location after pulling the side
fairing off. Outline in white boxes.

Caution:

Electrical

wires are connected to the side fairing.

Helpful hints: Use metric tools, clean hands, put the bike on a center stand. Do not pry on the screen excessively, as it will
break without much warning.

Installation Manual for Honda CBR250R

Thank you for purchasing Zero Gravity windscreen, which has
been designed and manufactured to give years of safe & fun rid-
ing. These instructions give you an in-depth look at the

installation process.

To receive further assistance or parts please e-mail [email protected].

PLEASE READ BEFORE

MOUNTING YOUR WINDSCREEN

Remove Side Fairing (For both sides)

Pulling the Side Fairing / Retention Clip Locations

Overview of screen and exploded view of assembly. It
might be a good idea to go get a 2nd helper with the
install. Remove side mirrors, set aside.

Removing Factory Screen Over View / Remove side mirrors

Here’s the side fairing screw location, there are two
more locations after this.

Note:

B screws are used.

Side Fairing Screw Locations Part 1 of 3

Here’s the bottom of the bike, side fairing screw loca-
tion. There is one more location after this.

Note:

B screws are used.

Side Fairing Screw Locations Part 2 of 3

Here’s the inner front cowl of the bike, side fairing
screw location.

Note:

A screw is used.

Side Fairing Screw Locations Part 3 of 3